Inquiry Basket (
Home » Offer List » Optical Fiber » 4E1-ETH Protocol Converter
Offer Details
4E1-ETH Protocol Converter
| Offer Type: |  |
|---|---|
| Offer Category: | Electrical & Electronics >Optical Fiber, Cable & Wire > Optical Fiber |
| Offer Post Time: | 2009-11-09 |
| Expiration Date: | 2010-01-16 |
| Details: |
Introduction
JFOPT 4E1/10-100Base-T Protocol Converter is an Ethernet Bridge specially designed to transmit Ethernet data over several E1 circuits. It enables point-to-point transmission of Ethernet MAC frame data through one to four E1 circuits, with a maximum designed transmission rate of 7.68 Mbps. They adopt de-multiplexing technology, which binds several E1 circuits together to transmit 10M/100M Ethernet data, allowing certain transmission Time lag difference. It can extend the transmission distance and scope of application of Ethernet with existing E1 circuit resources of telecommunications network and is an ideal Ethernet broadband access solution. Features Supporting transparent transmission of Ethernet data over 1 to 4 E1 circuits In compliance with IEEE 802.3 protocol, supporting 10M/100M, full-duplex/half-duplex working mode Supporting transparent transmission of jumbo frames specified in IEEE 802.1Q, and supporting Ethernet switch with VLAN function Built-in dynamic Ethernet MAC address list (1024) in the chip, supporting local data frame filtering function Built-in Ethernet data frame FCS check functional module, with check alarm output Built-in Synchronous Dynamic Random Access Memory (SDRAM) controller Optional butter area size to suit different types of services E1 interface complies with ITU-T G. 703, G. 705, and G. 823 recommendations, but does not support the use of signaling timeslot Built-in clock recovery circuit and HDB3 coding/decoding circuit in E1 interface module Supporting HDB3 code pattern Supporting availability detection and automatic fault handling for 1 to 4 E1 circuits Perfect line alarm indication and output Supporting the reset of a remote system from a local system Supporting E1 circuit loopback function New peer end alarm function, enabling the user to remove faults visually New lightning protection function, effectively preventing the threat of thunders and lightning on communication equipment Supporting remote alarm function, enabling a network administrator to judge a remote E1 line fault from the local end (applicable to the carrier-class NE-2708D) MTBF > 50, 000 hours, in compliance with carrier-class operation requirements (applicable to the carrier-class NE-2708D) Parameters 1. E1 interface Interface rate: 2048 Kb/s ± 50 ppml Interface code pattern: HDB3l Interface impedance: 75W/non-balancedl Jitter tolerance: In compliance with G. 823l Output jitter < 0.05 UI 2. 100/10Base-T interface Compatible with IEEE802.3/IEEEE802.3U Ethernet standards Supporting 10M/100M, full-duplex/half-duplex working model Dynamic address list storing 1024 Ethernet MAC address Supporting automatic address update and local data frame filtering functions Ambient temperature: 0º C- 60º C Relative humidity: 5% - 95% Atmospheric pressure: 86 - 106 Kpa Power parameter: AC180V-240V (50Hz/60Hz) power consumption < 5W Weight: 5.18kg (two sets) Package Dimension: 58cm*30cm*16cm (two sets) |
